Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2005

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Headlamp Rewiring= Crimp-on or Solder connections for more electrical flow???

posted by  raidman on  Sun Apr 25 11:33 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Apr 4 22:17 CST 2014
[RELATED]

I plan to make up wiring harnesses for both son's 83 245 and my 89 740 to increase electrical flow to the headlamp bulbs. I am going to use 12 guage wires to get full 12 volts to them.
The last one I made up for wife's 93 245, I soldered the connections and covered them with heat shrink tubing. Works great (but see below) .
Now I just read on the BrickBoard that a CRIMP-ON connector allows more amperage to flow,than a SOLDERED connection.
Which should I use for the maximum light from my bulbs?
Gracias,
el Raidman






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Headlamp Rewiring= Crimp-on or Solder connections for more electrical flow???
posted by  raidman  on Sun Apr 25 11:33 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.