Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Just took off tailshaft housing - a few questions 200 1986

posted by  smith_t240 on  Mon Apr 26 15:12 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Apr 24 02:21 CST 2007
[RELATED]

Well first off I have an automatic AW 70/71 transmission in the car. It leaked fluid from the rear seal of the tranny so I figured I should replace bushign too. I have the tailshaft housing off.

1) Should the seal be pressed back tight against the bushing?

2) Is it necessary to apply some type of compound to the splines of the flange ? It smells as if there is some compound there.

3) What is the torque for:
a) the 6 tailshaft bolts
b) the retaining bolt for the flange
c) the 4 bolts holding the driveshaft to the flange
d) 4 bolts holding tranny support ( any specific torque ? )

4) Do you know of any replacement tranny bolts in the pan? I broke 2 of them off in the pan earlier. I hope I can extract them with an extractor?? Ideas?

Thanks guys/gals,

Smith






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Just took off tailshaft housing - a few questions [200][1986]
posted by  smith_t240  on Mon Apr 26 15:12 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.