Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Removed /Replaced Intake - now, horrible clacking noise. 200 1983

Pulled the intake away from the head to install one of Dave Barton's "new" wiring harnesses. Could hardly believe the extensive deterioration of the original wires once out in the daylight for a good look - lucky not to have had a disaster! Reassembled everything with new gaskets, rebuilt injectors, cleaned-up oil separator, throttle body, and IAC motor, new plugs and wires.

The engine fired after a few turns (refilling the fuel rail and FPR) and ran very smoothly for a few seconds, but then started making an intermittent, loud "clacking" noise. (Okay, here goes: clack...clackity-clackity....clack, clack-clackity...you get the idea). This seems to be coming from the head/manifold area. Very loud, metallic rap.

Any ideas - other than the worst case of: "something got dropped in the intake and is clattering around"? (I'm mentally preparing myself to pull manifold, and if nothing appears then, to pull the head. Don't want to run the engine any more with this ugly sound. What a bummer.)

Thanks for any suggestions!
--
Bob (81-244GL B21F, 83-244DL B23F, 94-944 B230FD; plus grocery-getter Dodge minivan, MGB, and numerous old motorcycles)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Removed /Replaced Intake - now, horrible clacking noise. [200][1983]
posted by  Volvodad subscriber  on Sat May 1 14:24 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.