Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Misfiring on No1 cylinder only on starting for a 1992 245 200 1992

posted by  ToT5 on  Sat May 8 08:50 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I have a problem starting my 1992 245 Torslanda with both a warm or cold engine. Car turnes over fine, but starts on 3 cylinders. Two checks have now shown that the problem affects No1 Cylinder. I've changed the Distributor cap, rotor arm, sparkplugs, and HT leads. I've had the plugs out, and checked gaps and condition. I did note that the No1 plug was lighter in colour than the other three. Plug smells of gas and is wet. After 30 seconds to a minute or two, the car picks up on all four, and all is well. Car drives fine, and has full power during driving.The engine uses Bosch LEjetronic fuel injection.
Help appreciated as I'm beginning to think of some off the wall causes.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Misfiring on No1 cylinder only on starting for a 1992 245 [200][1992]
posted by  ToT5  on Sat May 8 08:50 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.