Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Two exhaust manifold questions 200 1988

posted by  scorch on  Sun May 16 10:14 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

1. If I disconnect the bell housing-front pipe bracket and leave the exhaust manifold connected to the front pipe, will I be able to take the exhaust manifold off far enough to replace its gaskets? Since I recently replaced the front pipe gasket, I don't want to have to disconnect the manifold from the front pipe and have to replace those copper nuts again.

2. Can I reuse the exhaust manifold nuts?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Two exhaust manifold questions [200][1988]
posted by  scorch  on Sun May 16 10:14 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.