Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2004 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

M41 wont disengage 120-130

posted by  OlyVolvo on  Wed May 19 18:18 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hello, I have this J-type M41 attached to my new motor and I cannot get the clutch to disengage. When I first started to run the car it would go into gear, but it was very difficult. Now, after only an around the block run, it will not go into any gear but 4th, and even then it is very stiff. I have the hydraulic clutch nightmare on this car, freshly bled, and adjusted fully out. It seems to have maximum travel, but I do not have that "over the center" feeling in the pedal like I am fully pushing in the pressure plate. Of course, it is happy to go in gear with the engine off, and it does not seem to roll or make any sound with the clutch out.

It is a mystery to me...

Any ideas?

Thanks,
Josh






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New M41 wont disengage [120-130]
posted by  OlyVolvo  on Wed May 19 18:18 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.