Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

No wonder my wagon was vibrating so bad!! 200 1986

posted by  philvo on  Fri Jun 4 11:01 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Aug 15 14:26 CST 2014
[RELATED]

I finally got time to replace my rear u-joint today.When I had the driveshaft in the vise I noticed one "arm" of the 4 in the u-joint was missing the needle bearings!It was just banging around in the bearing cap and it wore a pretty good groove in the steel.
It was pretty easy to replace,I don't know why I was apprehensive about removing the driveshaft,that was the easy part.
It rides so much smoother now.I put grease fittings on the other 2 u-joints and gave them some new grease while I was under there.
I think I'll do my pinion seal on my '90 now that I know it's not that bad of a job.
Sometimes you just have to go for it.
--
philvo '86 245 218k,'90 240 198k,'87 SAAB 900 SPG 213k






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New No wonder my wagon was vibrating so bad!! [200][1986]
posted by  philvo subscriber  on Fri Jun 4 11:01 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.