Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

240gl starts then stalls IAC power short? 200 1988

posted by  c wolfe on  Sun Jun 6 09:28 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

This site has been great help to me many times but i finally have a problem where i could use some advice.
1988 240GL LH jetronic 2.2
car will start then will stall within a few second (when it comes down to idle speed)
If i remove hose leading to the IAC (where it connects to flex hose in front of throttle body)and plug half of it with my thumb i can get the car to run and idle at 750 rpm but it stalls if throttle is applied.

Just checked IAC harness connector middle terminal to ground:
no volts, and 0 ohms with key in any position.
Any help is greatly appreciated.

Background:
New FPR
IAC cleaned (not inside), Checked ohms, applied 12v and it moved
TPS tested OK
FI relay resoldered
both fuel pumps working (pressure not checked)
Injectors have correct ohms





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240gl starts then stalls IAC power short? [200][1988]
posted by  c wolfe  on Sun Jun 6 09:28 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.