Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

WIRING QUESTION FOR MY IN DASH RADIO 200 1986

Recently, you may have seem my posts where I had been blowing fuse #8. Well, I finally tracked it down to my radio. My son had wired a Blaupunt radio/cassette unit into the existing wires that had had a factory Volvo radio in all the car's life. All had been well for about 10 months until I started blowing fuse #8. I looked at the fuse bar list of fuses and noted that fuse #1 is where the radio should be tied into. There are only 3 wires coming off of the back of the replacement unit Yellow for power, Red to the ignition switch and Black for ground. I have everything in place now, but when I turn the car off, I loose everything I set up. Coming off of fuse #1 is a yellow with black stripe wire. A green one is to fuse # 8. Where is the ignition wire I should be tying into. I'm lost. The Haynes manual doesn't show this detail.

Any help would be appreciated..... Thanks..






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New WIRING QUESTION FOR MY IN DASH RADIO [200][1986]
posted by  Xraybob  on Thu Jun 17 11:03 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.