Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2018 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

'91 740 TB change, possible problem with tensioner 700

posted by  someone claiming to be Shawn on  Thu Jun 17 15:51 CST 2004 [RELATED]

I recently replaced the TB, crank seal, and tensioner. I could not get the tensioner assembly to seat completely flush with the face of the block. The small studd on the tensioner backing plate will not go completely into the hole on the block. The belt is entirely on the tensioner, though barely. Will this be a problem? Any recomendations will be appreciated.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New '91 740 TB change, possible problem with tensioner [700]
posted by  someone claiming to be Shawn  on Thu Jun 17 15:51 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.