Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2001 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

where do the hoses go 700

posted by  VW on  Tue Jun 22 05:11 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

On my '86 760 Turbo, B230FT engine, there are three small hoses connected to the engine side of the intake manifold body. One heads to a hole through the firewall. This one has a split about an inch long. What does this connect to?
An other one just went over the back of the engine. When tracing it I came to a broken end just over the rear of the engine. What should this attach to?
Following the lines up from the oil trap to the flame arrestor, there is a large hose off one leg of the "Y" but nothing on the smaller leg. Should there be a hose here, and if so, where should it connect?
I'm still trying to track down an oil leak on this side of the engine and when driving the wagon it doesn't seem to want to downshift into a lower gear when the throttle is fully depressed. Just doesn't have any guts.
Thank you for any information you can share with me.
Ron






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New where do the hoses go [700]
posted by  VW  on Tue Jun 22 05:11 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.