Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

M46 OD 200 1981

posted by  Chad M on  Mon Jul 5 13:03 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

If you were swapping out an OD unit, which flange would you separate it at? I have my replacement OD ready to go, including the aluminum intermediate housing (last section before the cast iron). I was wondering if it would be easier to leave the old intermediate housing on the transmission and split it at the next flange back. That way lining up the cam on the output shaft would be simpler. What do you think? OD guru?
Chad.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New M46 OD [200][1981]
posted by  Chad M  on Mon Jul 5 13:03 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.