Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Has anyone found a new way to route/wrap the automatic OD solenoid wiring? 200

posted by  someone claiming to be Kyle245 on  Wed Jul 14 03:12 CST 2004 [RELATED]

I replaced the auto trans in my car and while doing the swap I found that my last repair on the OD solenoid using the flexible corrugated wire wrap looked like a mess.

The corrugated plastic wrap had melted to the top of the transmission.

The wiring wasn't damaged but I'm wondering if it is necessary to run the wiring the way Volvo meant for it to be run. It originally comes out of the floor then over the transmission to the passenger side of the trans and then back over to the drivers side of the trans to the solenoid.
I'm wondering if anyone has perfected a new way to run the wiring using some other type of flexible wrap that won't melt to the trans.

I seem to remember that the original wiring wrap had melted in a similar way.

Can I just drop the wiring down on the drivers side and put it through the hold down that is right in front of the solenoid?


Any help is greatly appreciated.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Has anyone found a new way to route/wrap the automatic OD solenoid wiring? [200]
posted by  someone claiming to be Kyle245  on Wed Jul 14 03:12 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.