The message to which you are about to reply is shown first. GO TO REPLY FORM
posted by
someone claiming to be Kyle245
on
Wed Jul 14 03:12 CST 2004 [ RELATED]
|
|
I replaced the auto trans in my car and while doing the swap I found that my last repair on the OD solenoid using the flexible corrugated wire wrap looked like a mess.
The corrugated plastic wrap had melted to the top of the transmission.
The wiring wasn't damaged but I'm wondering if it is necessary to run the wiring the way Volvo meant for it to be run. It originally comes out of the floor then over the transmission to the passenger side of the trans and then back over to the drivers side of the trans to the solenoid.
I'm wondering if anyone has perfected a new way to run the wiring using some other type of flexible wrap that won't melt to the trans.
I seem to remember that the original wiring wrap had melted in a similar way.
Can I just drop the wiring down on the drivers side and put it through the hold down that is right in front of the solenoid?
Any help is greatly appreciated.
|
|
* = Field is optional.
+ = Enter space delimited labels for this post. An example entry: 240 muffler
©Jarrod Stenberg 1997-2022. All material except where indicated.
Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.
