Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2016

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Bellhousing to M46 bolt is stripped.

posted by  someone claiming to be Dan on  Thu Jul 15 19:27 CST 2004 [RELATED]

Would it be OK to run without this bolt, its the top left bolt Ώ of 4 bolts holding the bellhousing to the trans].

I figure between the cross member, the other 3 bolts from the bellhousing to M46, and the BH to motor bolts, i should be ok.

I don't really see any serious issue with torsion, unless the motor rocks [twists] quite a bit, but my motor mounts are in great shape, so i figure any stresses on that section would be minimal.

I am going to run it to the machinist here tomorrow, see if he can run a thread chaser or retap it.

Any ideas? Would it be OK to run without the bolt there if worse comes to worse?

Again, this is the bellhousing to transmission bolt, not a bellhousing to engine bolt.

Dan






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Bellhousing to M46 bolt is stripped.
posted by  someone claiming to be Dan  on Thu Jul 15 19:27 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.