Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Door trim attachment 200

posted by  Runinturtle2 on  Sun Jul 25 21:38 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

The rearmost clip on the front passenger door trim outside near the door handle is located almost up against the plastic endcap of the support channel in the trim piece (at the rear edge of the door). In trying to replace this clip with a new one, I cannot remove the broken piece of the old clip that remains in the channel without what seems to be excessive (damaging) force.
.
If not removed, this piece occupies the spot for the new clip. Can this plastic be pulled out in pieces with a needlenose without damaging the edges of the channel? Any tips or experience?? Thanks
--
Jim (90 244DL 170K miles) turbo sways w/poly, front struts & bushings, OD wiring






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Door trim attachment [200]
posted by  Runinturtle2  on Sun Jul 25 21:38 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.