Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2008 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

AC pressure switch 700

posted by  corsair f5 on  Mon Jul 26 03:59 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hello
I did the R134 conversion from R12 on my 87 740 GLE B230F and I am getting 41 – 43 at the center vents.
I read on the board that the pressure cycling switch should be recalibrated to cycle the compressor at 24 psi for R134 as apposed to 30 psi for R12.
The only pressure device I can see is the relief valve on the compressor and the high cut out on the dryer.
Where would the pressure cycle switch be located, or do I need to install one in the system. Also what are the ramifications of running without one?
Thank you for your time, Louis Smith





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New AC pressure switch [700]
posted by  corsair f5  on Mon Jul 26 03:59 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.