Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

K-Jet Air/fuel control unit rubber mounts - how to replace? 200 1980

posted by  zrubin on  Sat Aug 14 13:05 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Sep 20 15:45 CST 2012
[RELATED]

On my 1980 245DL B21F, the air/fuel mixture control unit (the metal item that the rubber boot sits on under the throttle body) is supported by two rubber cylindrical pieces - the front one has a bolt connected to a metal disc that seems like it was glued to the face of the rubber piece. The disc has separated from the rubber piece, so the control unit is tilting down, making it tough to get the boot on properly. I removed the bolt and disc, but it's not obvious how to get the rubber piece off the control unit to replace it - is it pressed on, screwed on, glued on? Does anyone know what I'm talking about - any tips are appreciated. Thanks

Zack
1980 245DL M46 273k
1988 745T+ M46 194k






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New K-Jet Air/fuel control unit rubber mounts - how to replace? [200][1980]
posted by  zrubin  on Sat Aug 14 13:05 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.