Volvo RWD 444-544 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2004 444-544 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Oblong holes, Is it OK to weld material to the generator? 444-544

posted by  someone claiming to be mario on  Tue Aug 17 14:24 CST 2004 [RELATED]

I am in the process of fixing the fan belt/waterpump/radiator issue on my 61 wagon. I have already fixed the oblong holes on the alternator bracket with some washers and filling in with some welding, it looks great. Now I have to contend with oblong holes on my generator (or is it a dynamo?) mounting ears. One side of the generator is composed of a non-ferrous (not weldable with my gear) and the other side looks as if it is made of iron or steel. The side which is ferrous is the worse side. I was wondering if it would damage the alternator to weld the ear like I did with the bracket? I would put the grounding clamp right next to the weld, but is there a good chance of frying something?? If anybody has a 6 volt generator that has a good housing I would appreciate it. Any help or suggestions would be greatly appreciated.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Oblong holes, Is it OK to weld material to the generator? [444-544]
posted by  someone claiming to be mario  on Tue Aug 17 14:24 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.