Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

York Compressor Clutch 200

posted by  someone claiming to be djriverdance on  Tue Aug 24 07:08 CST 2004 [RELATED]

Thanks to numerous discussions on this board, I have ascertained that it is very easy to replace the clutch-pulley assembly on a York compressor (much easier than removing the whole thing). One bolt, and it's done.

Just two questions.

1) What's the torque on re-tightening?

2) Can you tell just by looking if a clutch/pulley assembly from a junker is any good? Or should I shell out at a parts store?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New York Compressor Clutch [200]
posted by  someone claiming to be djriverdance  on Tue Aug 24 07:08 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.