Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2002 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

700 fender side turn signals, how to run the wires? 700 1990

uid 19712's pic
posted by  Three Fat Tigers on  Sun Sep 12 06:48 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

The patient: http://www.threefattigers.com/Projects/Project760/

I've looked and so far I cant figure out how to run the wires, I know the door switch wiring is in the same location but again I dont know how that is routed into the car. I've looked at a few cars with the fender removed, including a 960, they all look pretty much the same under the fender, and still can't see how it is done. I know the V70/850 runs the wires under the fender to the front of the car, but I'm not pulling the fender or drilling holes for the factory clips to do that.

I know others have done the before me so how is it done?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 700 fender side turn signals, how to run the wires? [700][1990]
posted by  Three Fat Tigers  on Sun Sep 12 06:48 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.