Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2016 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Seat back heater grid - urgent 200

uid 25912's pic
posted by  Sven's Maintainer on  Sat Sep 18 10:44 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Sep 16 20:44 CST 2012
[RELATED]

I'm part way through repairing the foam in my '89 240 seat back.
My question is on the seat heater grid.

I'm not sure how it was supposed to be installed - I'm not confident that it was "OEM" before I opened it.

Is the grid supposed to be attached to the seat with clips? The grid was not attached to the back at all, only by the red wires. Grid was right between the seat fabric and the foam. There's a cutout in the left side of the grid's plastic frame that looks like it might hold a thermostat, but there's nothing in there. Any known purpose for the opening?

Top edge of grid will be near the wire rode/hog ring setup, about 1/2 way up the front of the seat back. Does the grid get clipped to that? Or is it supposed to be loose inside the seat upholstery? I'm planning on using plastic wire ties to replace the hog rings.

Thanks!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Seat back heater grid - urgent [200]
posted by  Sven's Maintainer  on Sat Sep 18 10:44 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.