Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

rear axle help (1990T wagon) 700

posted by  someone claiming to be jonnyb on  Sun Nov 7 07:41 CST 2004 [RELATED]

Was pulling the rear axle for a bearing replacement that will be done tomorrow and was following Chiltons manual. Axle was easy enough to pull however, Chiltons refers to a "toothed wheel" pressed onto the axle 116mm from the end. There is no toothed wheel on my axle. So pulled the axle from a 1987T wagon parts car i have. No toothed wheel on that axle either. What is the deal? Is the toothed wheel still inside and no longer pressed onto the shaft? Is this normal or abnormal? Do I just replace the bearing and put the axle back in and everything will be fine?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New rear axle help (1990T wagon) [700]
posted by  someone claiming to be jonnyb  on Sun Nov 7 07:41 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.