Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Chainsaw blowe replacement without airflow loss 200 1984

posted by  Eviljosh on  Wed Dec 15 20:54 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I think i may have found a way to prevent airflow loss when using the chainsaw method.

In the chainsaw guide, it says to remove 3 pieces of the inner housing to allow the blower motor mounting ears to pass through. If you are carefull and keep the pieces you can glue them back into place, thus creating a seal again and preventing airflow loss.

I will take pictures of what im talking about but im in trouble at the moment finding a replacement motor. Does anyone know how to restore the motors??

Cheers






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Chainsaw blowe replacement without airflow loss [200][1984]
posted by  Eviljosh  on Wed Dec 15 20:54 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.