Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2009 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Engine block drain plug 700 1989

posted by  Nmaslan on  Tue Dec 21 17:42 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Dec 30 18:34 CST 2011
[RELATED]

Hi

I will be doing my second coolant flush soon. Previously I opened the block drain plug and nothing came out. I then unscrewed the whole thing out (a nut and a brass cylinder fitting with holes) and still no coolant. I tried poking a small screwdriver into the hole with no success. I'm pretty sure I got the correct plug, located under the 4th cylinder right side of engine (ie exhaust manifold side).

So in preparation, if the drain hole is still blocked this time around what should I do? Would there be a lot of old coolant trapped in the block if the one did not drain it from the block and just removed the radiator hoses?

Any suggestions much appreciated.

Aslan





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Engine block drain plug [700][1989]
posted by  Nmaslan  on Tue Dec 21 17:42 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.