Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2008 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

B230FT I need help with the valve/crank timing! 900 1992

posted by  Brent529 on  Fri Dec 24 08:30 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hi all,

Got everything apart, cleaned up the block - got my new gasket kit and would like to put this rig back together..however.

- the books make it sound cake to line up all the marks...( after you've removed half the engine (crank pulley, timing cover (lower) etc..)

I did find another pic on alldatadiy.com showing to line up a groove on top of the crank pulley with a 0 deg notch on the timing marks on the lower timing belt cover..

OK so the top 2 marks are easy. however... if you line this bottom one up with 0. the #1 piston is NOT at TDC its about 1" below....

whats up with that?

is this correct?


ok went back out and looked some more... if you line up the DOT (indentation on the FACE of the pulley) w/ the 0 mark your at TDC...

but the "line" they picture puts you about 1" below tdc..which do i use??









THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New B230FT I need help with the valve/crank timing! [900][1992]
posted by  Brent529  on Fri Dec 24 08:30 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.