Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2004 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

How to put carpet insert back in door panel? 700

posted by  N7SC on  Sun Dec 26 11:13 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Jul 7 14:12 CST 2013
[RELATED]

Took the interior panel off of the passenger-side rear door of my '91 745T today. Removed it per the FAQ, but managed to pop off the carpeted trim insert above the arm rest/door handle cup/window switch panel. The carpeted insert has molded-in clips that slide on over little white nylon studs that stick out from the door panel. BUT, the openings of the clips on the carpeted panel don't all face the same way. Like, for example, if the openings all faced forward, then you would line up the panel to the rear of where it should be and slide it forward on to the nylon studs. Problem is that the opening of the front clip faces toward the back of the car, and the other two face forward.

Anyone else ever have to put one of these back on and know how to do it? Also, if you break off one of the little nylon studs on the door panel, can you replace them?
--
Scott Cook - 1991 745T, 1985 RX-7 GSL-SE, 1986 Toyota Tercel (Don't laugh, it is reliable, faithful AND gets 41 mpg!)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How to put carpet insert back in door panel? [700]
posted by  N7SC  on Sun Dec 26 11:13 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.