Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2024 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

stuck blower impeller 200

posted by  interstition on  Mon Dec 27 09:10 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Apr 28 10:13 CST 2014
[RELATED]

I'm using the chainsaw method to change my heater blower, but can't get the right impeller off. The clip is off, I have tried holding the other side of the shaft and also running the motor while holding the impeller while pulling in hopes of "spinning it off". So far, it will move out about 1/4 inch, but that's all. Of course, with the hole I cut, I can only really access one side of the impeller with my hand, but I did get a string behind it to help me pull. No help.

I gave up for now and plan to go to the pick-n-pull to get a spare impeller since I think when I pull a little harder I will break it.

Any ideas would be appreciated in the mean time.

--
Andy in St. Paul, '91 745 Regina 198K mi, '89 244 142K, '87 245 RIP






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New stuck blower impeller [200]
posted by  interstition  on Mon Dec 27 09:10 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.