Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Which U-Joints should I replace? In what order based on long term stress and wear? 200 1987

posted by  Mr. Tool on  Wed Jan 5 01:45 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Sep 1 17:19 CST 2014
[RELATED]

Hello all:

I have a 1987 240 Volvo Wagon, B230F engine, Automatic Transmission, 195,00 miles.

Based on a previous posting, I now plan on replace my U-Joints in the drive shaft.

There are 3 sets of U-Joint.

Moving from the back of the car towards the front they are as follows:

1. Rear U-Joint at rear of driveshaft that connects to the rear axle/diferential.

2. U-Joint at the center support bearing.

3. U-Joint at the far front of the driveshaft, just behind the tailshaft of the transmission.

I'm thinking that not all of these need to be replace.

QUESTION? What would the order of replacement be? I'm assuming that some U-Joints get more stressed than the others and would be first candidates for replacement.

Any assistance would be appreciated.

Thanks........Mr. Tool


--
Mr. Tool






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Which U-Joints should I replace? In what order based on long term stress and wear? [200][1987]
posted by  Mr. Tool subscriber  on Wed Jan 5 01:45 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.