Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2014 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Intake Manifold Possibly Overtorqued - Consequences? 700

posted by  someone claiming to be patrat66 on  Thu Jan 6 04:29 CST 2005 [RELATED]

Hello,

Just got my intake manifold back on my 1988 760 turbo after fixing the problem described in one of my other posts: http://www.brickboard.com/RWD/index.htm?id=895813

I tried to torque the intake manifold nuts to 15 lbs. as recommended. The torque wrench never clicked to let me know I reached this level and I'm afraid that I may have overtightened the nuts as I was really cranking on them. What are the possible problems with this? The engine seems to run fine. I would like to back off the nuts and try to retorque, but I'm concerned that I won't get a good seal because either the gasket was compressed too much to rebound to its original thickness or I may have twisted the manifold itself (warped it). Also, would I have to replace the studs because of possible stretching? What are the possible repercussions of overtightened intake mainfold nuts?

Thanks for your help!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Intake Manifold Possibly Overtorqued - Consequences? [700]
posted by  someone claiming to be patrat66  on Thu Jan 6 04:29 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.