Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

FRONT SWAYBAR BUSHING QUESTION 200 1986

posted by  Xraybob on  Sun Feb 20 07:29 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 05:32 CST 2014
[RELATED]

I recently aquired a front and rear set of upgraded swaybars for my '86 sedan. I installled the rear already and am ready or order the bushings for the front.
My question is IPD sells the poly bushing for the lower end link in poly for $9.00 per side, but not including the endlink itself. I'd have to use my old one, which is fine with me. How difficult is it to get that bushing into the endlink? I could get the entire assy endlink and all in rubber from FCP Groton for $12 per side, but I'd rather have it in poly. How do I go about removing the old rubber bushing and installing the new poly one should I decide to go the IDP way? I can't wait to get this upgrade done.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New FRONT SWAYBAR BUSHING QUESTION [200][1986]
posted by  Xraybob  on Sun Feb 20 07:29 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.