Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Recirc vent flap: expected functionality: humidity issue fixed 200 1989

Well a few weeks back I posted about intermittent humidity blowing and fogging up my windshield.

It turns out it was not a leaky heater core, no issues there thank goodness.

I checked the recirc flap behind the center dash. After removing the passenger side cover, I put my hand behind the core and noticed the position of the vent flap (car running, non-recirc). The flap was almost at 6 oclock (pointing down i.e. virtical). I slightly gave it a push and it went up to a 45 degree angle pointing at 4:30 (45 degress towards the firewall). When I push on recirc, it now goes to 6 o'clock. When I remove recirc it points to 4:30. I assume it was slightly jamming.

No more apparent humidity issues.

Q: Does this vent flap only travel a total of around 45 degrees? Can I assume that it functions as expected now? Also, it's motion was relatively slow, takes 1-2 seconds to open or close. I put my finger in there though and I can say that it crunches it pretty tight!

Let me know what you think - thanks!

Greg Mustang
Montreal Canada






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Recirc vent flap: expected functionality: humidity issue fixed [200][1989]
posted by  greg_mustang  on Thu Feb 24 02:30 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.