Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

84 244GL alt belts 200

posted by  frustrated_in_van on  Fri Feb 25 10:03 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Jul 2 18:24 CST 2010
[RELATED]

hi.

I just swapped out the brushes on the original bosch alt and it worked really well. getting ~14.2V on the battery at idle and minimum load.

However, the alt belts are badly worn and need replacing. The thing I can't figure out is that while I can rotate the alt on the swing arm to loosen them I can't fully remove them because of the belt that runs from the engine to the PB block. From there there is another belt which runs up to the AC compressor which I can also loosen and rotate out of the way.

So I guess my question is: how do I remove this short belt at the bottom in order to get at the alt belts. There seems to be no way to loosen off this short belt. I read the 700/900 FAQ on this but it didn't seem relevant to my situation.


Thanks,

Chris






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 84 244GL alt belts [200]
posted by  frustrated_in_van  on Fri Feb 25 10:03 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.