Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

ALLANWAYNE 200

posted by  RLC on  Sat Feb 26 01:22 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Do not use Channel Lock Pliers on the Cast Aluminium Bosch JFU4 Distributor! I will scar it or possibly crack it.

Use a Block of Wood and a Ball Peen Hammer. Place the Block of Wood up against the Base Plate where the Distributor Hold Down Bolt goes. Shift it one direction then the other.

If you ever remove the Distributor, ask me.

The Brass Screw with the Coil Spring beneath it is the Idle Trim Screw. Screw all the way in. Check how the car idles and runs. I suggest unscrewing it 1/4 Turn and leave it.

The other screw, looks like a wood screw, has a spring attached to it for the Throttle.

The Brass Plug on the inlet manifold is suppose to be the main Idle Speed Adjustment. It seems difficult at best to adjust it, using a tachometer.

There is likely no Bypass on your Carburetor. The Chilton and Haynes are very generic, if not ambiguous. The Zenith-Stromberg 175CD Carburetor is used on so many different cars and trucks, including various Volvos.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New ALLANWAYNE [200]
posted by  RLC  on Sat Feb 26 01:22 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.