Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Nuts! 700

posted by  Greydog on  Wed Mar 2 12:33 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Okay, Gang,

I've been trying since last Friday to get the front crossmember nuts off of my '90 745 to do an oil pump change.

I've tried everything. Gallons of PB Blaster, impact wrench, breaker bar with (no kidding) a 3' "extension". I've tried heating them with my MAPP torch. I've even tried the "candle wax" trick. All that did was result in hot wax dripping down my sleeve. I bought a nut cutter, but it won't reach where I need to get.

I'm afraid that if I continue along this path, I'll snap the studs off and be in real trouble.

I've thought of trying to "Dremel" them in half, but I'm worried about ruining the threads on the studs, and it's kinda hard to reach them.

Anyone have any suggestions? Thanks for your help,

Greydog


--
Greydog....'90 Turbo Wagon.....really sweeeeeeeet!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Nuts! [700]
posted by  Greydog  on Wed Mar 2 12:33 CST 2005 >
  • New Nuts! [700]
    posted by  Steve subscriber  on Wed Mar 2 14:27 CST 2005 >
  • New Nuts! [700]
    posted by  745 TurboGreasel  on Wed Mar 2 18:45 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.