Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2004 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

WON'T CRANK 700

I just installed a new engine wiring harness for a friend. I'm not getting any voltage at the starter solenoid. Now, that symptom developed BEFORE I replaced the crumbling harness, so I assumed it would go away with a new harness installed. No such luck. I can jump the solenoid and the engine will start and run just fine, but I'm not getting an impulse from the ignition switch to the solenoid. Is there some sort of relay or something in between that I should check?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New WON'T CRANK [700]
posted by  Michael Major  on Mon Mar 7 08:13 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.