Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2013 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Taillight nut - size? 200 1989

posted by  Eric-S on  Thu Mar 17 11:10 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

The four nuts that hold a taillight assembly in place: Is there a specific name/size for it? I know that a 10mm wrench and/or a deep socket is needed to tighten/loosen the nuts (aka to remove the assembly).

I went to Ace yesterday trying to get a replacement nut, but I could not find one that matches the others. The nut has a washer-type backing attached to the front. I believe the inner threads are M5 (??) while the actual nut itself is 10mm? The only M5 threaded nuts that Ace had were extremely tiny -- nowhere near 10mm in size.

Is there a direct replacement or do I have to get a separate washer and nut? If so, does anyone know the sizes I need to help me eliminate the guess work? I can't believe how much trouble I am having with something that should be quite simple. Thanks!
--
Regards,
Eric Staufer,
1989 244DL 129k,
My 240 Page (opens a new window)
(recently updated - new URL!)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Taillight nut - size? [200][1989]
posted by  Eric-S  on Thu Mar 17 11:10 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.