Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

ball joint taper - just turns - can't tighten to 44 ft-lbs 200

posted by  someone claiming to be andy crosby on  Fri Mar 25 07:50 CST 2005 [RELATED]

What am I missing? I got a new ball joint kit. But when I put the tapered shaft into the strut anchor tapered hole, then try to tighten the top nut to 44 ft lbs, it just turns and slides in the taper - nothing to stop it. Can't pull it down until the taper "grabs" and allows torque. Tried putting it in a vise to pull it down first, but it's wobbly due to the ball action. Now can't get the nut on or off, but can't use it this way. There must be a well-known answer, but I don't see it in the FAQ or search, or Bentley or Haynes. Help - my brick is in pieces !

Andy Crosby
'85 240






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New ball joint taper - just turns - can't tighten to 44 ft-lbs [200]
posted by  someone claiming to be andy crosby  on Fri Mar 25 07:50 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.