Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2009 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

heater motor wiring 120-130

posted by  Tom O. on  Fri Mar 25 08:06 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I started servicing my heater motor today. I was pleasantly surprized to find out the only reason it wasn't working was that the wires were connected wrong. Now that I am trying to hook it up right, I discovered something weird and I am wondering if my heater fan switch is bad. I tested the three wires - when the switch is all the way out one wire is hot; when the switch is halfway out, that same wire is hot and another one as well. The third wire is never hot, so that must be ground. I can't think why there are two wires hot when the switch is half way out. I am not even sure what position the switch should be in for high and low fan. I assume that all the way out would be high, is that correct? Shouldn't there only be one wire hot for low, and one wire hot for high?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New heater motor wiring [120-130]
posted by  Tom O.  on Fri Mar 25 08:06 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.