Volvo RWD 444-544 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2004 444-544 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Exhaust Manifold studs 444-544

posted by  dencat on  Sun Apr 10 11:10 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Dec 9 17:36 CST 2009
[RELATED]

I found a dual pipe exhaust manifold and had to get new studs. It looked like 10mm studs were going to work good but not totally. They worked fine on the two positions where stud comes all the way through the manifold flange. On the third hole, it goes up into the manifold about 1". On this one the 10mm stud is not working. I can tighten it just so far then it gets loose again.
Should this stud be different from the other two? Differtent threads?
Or do I have screwed up threads in the manifold.
Dennis






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Exhaust Manifold studs [444-544]
posted by  dencat subscriber  on Sun Apr 10 11:10 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.