Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2011 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

ABS Relay prolem 700 1991

ABS light is on on my 1991 Volvo 740 Turbo Wagon. I followed the procedure on the FAQ (Diagnostic Unit Malfunction: Surge Protector Failure) and saw that Pin 2 (yellow/red wire) never has the +12V that it should. However, Pin 4 (blue/green) needs to be at ground for this relay to energize, and it is consistently as +12V. Question to someone with a schematic: where does this blue/green wire go?

Also, I temporarily shorted the yellow/red wire to the red wire and the ABS light went out, so the control unit is OK. Not knowing where the blue/green wire goes, I was afraid to short it to ground to test the relay.

Thanks,
LJE

2004 S60 2.5T, 1991 745 Turbo







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.