Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2003 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Anyone used these ferrule connectors? 900 1993

posted by  benfingland on  Fri May 6 01:30 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Aug 7 07:54 CST 2014
[RELATED]

Has anyone had any experience using ferrule connectors to "splice" a rubber hose into a metal trans. line? I have the more basic setup with my Magnefine filter hoses attached to the metal line with a couple of hose clamps. Problem is, it will leak slightly no matter how tight you clamp.

The ferrule connectors I got have nice tapered ends to clamp the hose to. But I'm skeptical that they are actually able to stay on the metal line by themselves or not leak, since there's no gasket material at all, and everything is just metal on metal. Am I missing some basic principle here, or should I just try to tighten the nut side on the line as much as I can and hope for the best? (or just stick with the setup I have now?)

Thanks for any suggestions!

-b






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Anyone used these ferrule connectors? [900][1993]
posted by  benfingland  on Fri May 6 01:30 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.