Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Vibration in driveline is hard to find! 200 1990

I have replaced all the mounts --both motor and the trans mounts, all 3 u-joints, the drive shaft support bearing the rear trans seal and the rear pinion seal. I still have a vibration that is there especially when I compare it to my other 2 bricks. I was thinking of going to a shop that I hope can find this problem or maybe balance the drive shaft itself if that would be possible. I do have 205 size tires and also new Bilsteins front and rear. Any suggestions???

Bill Nelson, Hartford WI






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Vibration in driveline is hard to find! [200][1990]
posted by  Bill N. subscriber  on Mon May 9 15:47 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.