Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2002 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

AW-71 tranny from '94 944t to '86 745t 700

posted by  tanuki on  Tue May 17 12:22 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

My wife has an '86 745t w/AW 71 tranny, which is leaking for the last time.
I've located a low mileage '94 944t AW 71 at my local U-Wrench-It, and want to know if it will fit, or what changes are needed. The '94 has a ball bearing output flange bearing; '86 doesn't. The '94 driveshaft is rubber cushioned, too, I think.
Obviously the '94 flange can't be changed, but will the '94 flange fit the '86 drive shaft? Or, if needed, will '94 driveshaft fit '86 rear axle flange?
How about the bell housing to engine, and converter plate to converter?
Thanx much for any and all help!
wk
Hope someone out there has at least some of these answers.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New AW-71 tranny from '94 944t to '86 745t [700]
posted by  tanuki  on Tue May 17 12:22 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.