Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

New crank position sensor - but now won't start 200

posted by  someone claiming to be Zach on  Mon May 23 08:01 CST 2005 [RELATED]

Hello again -

I posted last week about my old CPS being stuck - well - success on that point - finally got the liquid wrench to loosen things up and managed to pull the sensor out. Cleaned things up, put a light touch of grease on the outside of the new sensor, slowly worked it into the hole, plugged it into the harness, bolted the sensor it and went to fire up the car. No go! Checked to see if there was a spark and no luck. Grabbed the multimeter to test the CPS. Got about about 1800 ohms resistance - but testing alternating current while cranking the engine (AC set to 200) - no noticable signal. Is my meter simply not set low enough to measure it - am I not thinking of something else?

Help!

Zach






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New New crank position sensor - but now won't start [200]
posted by  someone claiming to be Zach  on Mon May 23 08:01 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.