Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

AMM adjustments with dwell meter 200

uid 6416's pic
posted by  archie777 on  Tue May 24 12:11 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue May 25 14:17 CST 2010
[RELATED]

Anyone done this? According to the Bentley manual you can adjust the CO with the AMM screw and Dwell meter. It said it should fluctuate between 20-70 degrees. Mine goes between 20 to 100. If I adjust the screw one way it will stay at 20 but if I adjust the other way it stays at 100 I basically split the difference and it fluctuates between the two.

Am I anywhere near being correct?

I also adjusted the base idle before and after and then checked the Dwell again.


Any Ideas if this is correct?

Thanks in advance Chris






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New AMM adjustments with dwell meter [200]
posted by  archie777  on Tue May 24 12:11 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.