Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2024 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Hard Plastic Fule Line on K-Jet 200

posted by  yellowbrickroadster on  Tue May 31 05:56 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 06:18 CST 2014
[RELATED]

On my 1980 242, there are some pieces of the K-Jet system that use a hard plastic fuel line (usually encased in a softer rubber sheath). This hard plastic line appears to be heat shrunk over the barbed fittings onthigs such as the frequencyu valve. Is it possible to buy this hard plastic line in bulk length, and if so, how do you work it onto the fittings for a tight, safe seal ? Reason for asking is that some of the components, like the frequency valve, whne rodred as a standard Bosch part, do not come with this hard hose attached. Thaks.

Mike






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Hard Plastic Fule Line on K-Jet [200]
posted by  yellowbrickroadster  on Tue May 31 05:56 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.