Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2020 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Torque spec woes 700 1988

posted by  Expat_88_765T on  Fri Jun 24 09:49 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]


Now that I got the turbo out and sent off for overhaul (@ 210K SM), I'm studying the reverse procedure and I end up confused; Haynes, Chilton and 700Faq are all stating different torque specs on turbo to manifold...
Does anyone have the real deal here? This is a 230FT with Mitsu TD05 turbo.
Chiltons: 1) 10Nm 2)41Nm 3)120 deg. more
Haynes: 1) 1Nm 2)45Nm 3) 45 deg. more
700 FAq: Tighten to 30 Nm (22 ft-lb) in a 1-4-2-3 pattern starting with the top rear as "1" and then going clockwise around the nuts ending at the bottom rear.

What does the Volvo Maint. Spec say? Anyone?

Secondary question: Does the oil return pipe have an o-ring in addition to the rubber gasket (into the oil pan)?

thx





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Torque spec woes [700][1988]
posted by  Expat_88_765T  on Fri Jun 24 09:49 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.