Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

a/c bypass and p/s pump concerns *HELP APPRECIATED* 200 1979

posted by  Lou Dogg on  Sat Jul 2 12:44 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Apr 29 21:29 CST 2011
[RELATED]

I guess my last message never posted. Anyhow, I purchased an A/C bypass from IPD, and after installing it, the pump vibrates violently above 2500 rpm. Tightening the belt cleaned up a little slop, but the pump still vibrates. Replacing the rubber mounts (bushings, I guess) did not help. The pump vibrates less when pulled forward. My questions:

1) How do I get this to stop? Whats causing this?

2) If I want to go back to my old setup, how to I get the crank-pulley-to-compressor belt on? Removing the A/C compressor wasn't that obvious to me...

3) Do you have any other suggestions to help with this?

If no other suggestions are given, please tell me how to take it back to the way it was!!!

Thank you in advance!!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New a/c bypass and p/s pump concerns *HELP APPRECIATED* [200][1979]
posted by  Lou Dogg  on Sat Jul 2 12:44 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.