Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

My gas guage reads 1/2 when my tank is full. 200


Brickboard,

My 1989 240 DL Sedan's gas gauge has started reading only 1/2 full when the tank is full. My wife says that once the tank gets to about 1/2 the gauge starts to work as expected with the needle dropping normally.

I put my hands behind the dash where the gas guage is and jiggled wires. No luck.

I am afraid someone is going to suggest taking the bung out of my tank. I may do more damage than good if I try. My bung is rusted pretty good. Not only that but I painted POR-15 on the whole area to try to keep it from rusting any more than it already is. So it is probably painted shut too.

Has anyone else experienced this problem? Any ideas? Please advise. Thank you.

2OldVolvos.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New My gas guage reads 1/2 when my tank is full. [200]
posted by  someone claiming to be 2oldvolvos  on Thu Jul 7 14:54 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.